I believe this was caused by the horrendous layer adhesion of this silk PLA. Didn’t have time to tune the filament, and based it off of another silk one.

  • anguo@lemmy.caOPEnglish
    2·
    2 days ago

    Everything that was supposed to be attached at the bottom of the bowl, wasn’t. There were three poles and some sort of tower, all with small footprints. All the supports weren’t attached either. I also could easily separate the layers with minimal force.

    I think you’re right that a bed slip caused a chain reaction, but the layer adhesion certainly didn’t help.

    • schmaker@schmaker.eu
      1·
      2 days ago

      @anguo

      I also could easily separate the layers with minimal force.

      I consider this information important as this mean it’s not sticking for some (not hot enough or not enough material?) reason.

      I only had splittable (not that easily though) layers with ABS/ASA, never with PLA or PETG