I usually use epoxy or 3M double sided adhesive tabs. This time the holes in the model I downloaded ended up being undersized, so heat setting seemed like a good plan. Guess not.

Definitely stressful, my dad had been a controller in the USAF. It’s where he learned to drink heavily when off duty. Of course, they were stationed in Greenland, so there wasn’t anything else to do.

“Voters should decide who our primary nominees are, not DNC leadership.” Since when has the DNC not put it’s thumb on the scales in the past few decades, or ignored the voters entirely?

Used to use Vent playing Eve Online 19 years ago. Worked great back then. Apparently it’s still around, but still no Linux support after all these years.

If you have an enclosure, I would say try out ASA. Similar to ABS, I’ve found it makes some really nice parts that are tough and UV resistant. Great for things you want to leave outdoors. Otherwise TPU is useful stuff too, and no heated chamber required. I was using it this weekend to print up seals and grommets for a trailer I’m rewiring. It’s nice being able to print up some parts I need rather than making a drive to the hardware store and hoping they’ll have something I can use.

Just put the comics section out of the Sunday paper in a frame for him. He won’t know the difference.

I agree that it’s probably a speed issue. When I first started printing, I was seeing just how fast I could go with PLA and tuning for that. Decided to try out PETG a few months later, and it was a disaster. Layers weren’t bonding properly, and the filament would bridge across points on the print. Once I backed print speed down to 50, I started to get much better results.

They probably won’t include all the federal employees being kicked to the curb in the unemployment numbers either.

That was Cory Doctorow’s recent take on it too. Trump just threw out the trade agreement with Canada and Mexico he was so proud to say was his accomplishment, after renegotiating NAFTA. They really should say fine, stew in your own mess. Ignore patents, crank out cheap pharmaceuticals, forget about DRM. Nationalize US factories on their soil. Will hurt for a while until new trade is established, but there is the whole rest of the planet to trade with.